Noise Level; Maintenance; Cleaning The Appliance - Fiorenzato XGR Manuel D'instructions

COFFEE OUTLET GUARD
The coffee outlet guard must always be fixed
to the doser unit using the relevant screws,
which must never be removed by the user .
The removal of the coffee outlet guard can
be done by skilled technical personnel only
after disconnecting the grinder-doser from
the power supply by unplugging . Before re-
connecting the grinder-doser to the power
supply, replace the safety device .

NOISE LEVEL

EEC COUNTRIES
The maximum noise emission of our coffee
grinders and grinders/dosers measured in
UNI EN ISO 3741 reverberating chamber
in compliance with the EN 60704-1 regu-
lations, is compliant with the EN 60704-1
: 1998 and EN 607043 : 1996 regulations .
The equivalent level of noise exposure of a
worker, exclusively related to limit of 240
min . per eight hours of use of the appli-
ance, is equal to 78 dB(A), in compliance
with ED 86/188/EEC and ED 200311 0/EEC .
Therefore, when operating the appliance,
no provisions need to be taken in order to
prevent such risks arising from noise ex-
posure in the workplace (articles 3-8 of ED
2003/10/EEC) .

MAINTENANCE

It is essential to periodically check the state
of the supply cable and plug . In the event
the supply cable or plug are damaged, call in
skilled technical personnel to replace them,
in order to prevent any risk . In CE-certified
appliances a special tool is required to open
the base plate to access the cable . We rec-
ommend using original spare parts only . In
order to assure the lasting efficiency of the
appliance, skilled technical personnel must
be called in to perform periodical mainte-
nance, including detailed checks of the state
of those components subject to wear . The
state of the grinding blades must be checked
periodically . Keeping the grinding blades in
an excellent state assures high-quality grind-
ing, resulting in greater productivity and
limited overheating .

CLEANING THE APPLIANCE

Disconnect the power supply from the
grinder-doser by unplugging it before clean-
ing . The appliance must not be cleaned
using water jets . Do not install the grinder-
doser in rooms where water jets are used
for cleaning . The grinder-doser must be
cleaned periodically by skilled technical per-
sonnel only . Use perfectly clean, disinfected
cloths or brushes for cleaning . Do not use
abrasive products as these are liable to take
the sheen off shiny parts .
HOPPER
Wash the hopper once it has been removed
from the appliance (unscrewing the relevant
fastening screw), using neutral soap and wa-
ter, rinse abundantly with lukewarm water
and dry thoroughly . It is advisable to clean
the hopper periodically . Once the hopper
has been cleaned, it must be attached to the
upper grinding blade holder using the rel-
evant screw .
GRINDING SYSTEM
Remove the safety screw which prevents the
adjustment disk from being removed . Un-
screw the adjustment disk by turning it clock-
wise . Having removed the upper grinding
blade holder, clean the grinding blades, the
threads and the entire grinding system thor-
oughly using a clean brush and cloth . Having
refitted the upper grinding blade holder in
the relevant slot, screw the adjustment disk
back on, and after refitting and securing the
hopper adjust the grinding as required .
29