Rfid; Grinding Mode; Standard Mode; Automatic Mode - Fiorenzato XGR Manuel D'instructions

• IMPORTANT: fasten the grinding adjust-
ment disk correctly (refer to the chapter
AUTOMATIC RECOGNITION OF THE FIL-
TER HOLDER CUPS – RFID) .

GRINDING MODE

Using the SETTINGS menu, you can now se-
lect from the various MODES OF USE for the
grinder-doser . For certain modes, where pro-
vided, the dose of coffee dispensed from the
coffee grinder-doser will be exactly the dose
set and calibrated (XG Technology) .

STANDARD MODE

Press for the required dose using the but-
tons C1 or C2 (automatic operation for XGR
models) . The selected button will begin to
flash . When the filter holder cup is pressed,
the start microswitch activates grinding .
Otherwise, pressing the button M, continu-
ous grinding is activated until the button is
released . The standard mode is factory-set .
To reselect it, access the SETTINGS menu,
select GRINDING MODE and then STAND-
ARD . In this way, the buttons will light up .

AUTOMATIC MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then AUTOMATIC . For a sin-
gle dose, press the start microswitch once
with the filter holder cup . For a double dose,
press twice quickly (this last operation is not
necessary for XGR models) . In this way, the
continuous grinding (button M) and the but-
tons C1 and C2 are deactivated .

PRE/SEL MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then PRE/SEL . Press the
required dose using button C1 or C2 (au-
tomatic operation for XGR models) . The
selected button will remain on and active .
Grinding starts when the start microswitch
is pressed by the filter holder cup . To switch
from one dose to another, press the appro-
priate button . In this way, continuous grind-
ing (button M) is deactivated .

DIRECT MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then DIRECT . Press the re-
quired dose by using the button C1 or C2
(automatic operation for XGR models) . Oth-
erwise, pressing the button M, continuous
grinding is activated until the button is re-
leased . In this way, the start microswitch is
deactivated and the buttons light up .
• During the grinding process, the time is dis-
played in seconds and tenths of a second .
• The button for the selected dose flashes
during dispensing .
• After dispensing, the counters are updated .
• For counting purposes, continuous grind-
ing corresponds to a single dose .

SAFETY DEVICES

THERMAL OVERLOAD PROTECTION
The grinder-doser motor is protected against
overheating resulting from overcurrents
by a thermal overload protection which,
when tripped, cuts off the power supply to
the motor . If the thermal protection device
should automatically turn on in the event
of anomalous operation (such as the grind-
ing blades jamming), turn off grinder-doser
using the On-Off switch, unplug it from the
mains, and contact skilled technical person-
nel . Never perform any work on the grind-
er-doser while it is attached to the mains,
in order to prevent the motor from turning
on suddenly . If the grinder-doser overheats
as a result of the motor stopping, allow the
grinder-doser to cool down before perform-
ing any repair work .
ADJUSTMENT DISK LOCK
In order to prevent the adjustment disk
from being removed, which would make the
rotating parts accessible, there is an anti-
unscrewing adjustment disk lock (safe) po-
sitioned under the adjustment disk .
28