Settings Menù; Coffe Dose Adjustment; Mills Replacement; Safety Devices - Fiorenzato F4A Manuel D'instructions

USER MENU
To access the user menu, keep the
pressed until an intermittent sound starts
(about 5 secs .) . Three yellow buttons will light
up . Use the buttons
the menu and change the setting . Use the but-
ton to select and confirm . Exit the menu af-
ter confirming by pressing the button
• Language
English, Italiano, Español, Français, Deutsch,
Português, Chinese, Russian, Korean, Malay-
sian, Thai, Greek .
• Time
Set time .
• Time Layout
12 or 24 hours .
• Date
Set date .
• Brightness
Percentage .
• Information
Firmware version and Serial Number .
SETTINGS MENU
To access the user menu, keep the
pressed until an intermittent sound starts
(about 5 secs .) . Three yellow buttons will light
up .Use the buttons
the menu and change the setting . Use the
button to select and confirm . Exit the menu
after confirming by pressing the button
• Grinding Time
Single and double grinding secs .

• Mills Replacement

Hours .
• Mills Reset
Reset mills timer .
• Factory Reset
Restore factory settings .
• Statistics
Show statistics .
• Manual Grinding
Activate manual grinding
COFFEE DOSE ADJUSTMENT
Access the settings menu, select Grinding Time .
button
and to move through
.
button
and to move through
button .
Then select the seconds for single grinding op-
tion and confirm . Adjust the seconds for the
double grinding option and confirm again .
MILLS REPLACEMENT
When the grinding mills need to be replaced,
a warning appears on the display . The state of
wear can be monitored by accessing the set-
tings menu and selecting Mills Replacement .
Important:
the replacement timer needs to be reset . To do
this, access the settings menu, select Mills Re-
set and confirm the reset .

SAFETY DEVICES

Thermal overload protection
The grinder-doser motor is protected against
overheating resulting from overcurrents by
a thermal overload protection which, when
tripped, cuts off the power supply to the mo-
tor . If the thermal protection device should au-
tomatically turn on in the event of anomalous
operation (such as the grinding blades jam-
ming), turn off grinder-doser using the On-Off
switch, unplug it from the mains, and contact
skilled technical personnel . Never perform any
work on the grinder-doser while it is attached
to the mains, in order to prevent the motor
from turning on suddenly . If the grinder-doser
overheats as a result of the motor stopping,
. allow the grinder-doser to cool down before
performing any repair work .
Coffee outlet guard
The coffee outlet guard must always be fixed to
the doser unit using the relevant screws, which
must never be removed by the user . The re-
moval of the coffee outlet guard can be done
by skilled technical personnel only after dis-
connecting the grinder-doser from the power
supply by unplugging . Before reconnecting the
grinder-doser to the power supply, replace the
safety device .

NOISE LEVEL

EEC Countries - The maximum noise emission
of our coffee grinders and grinders/dosers
22
After replacing the grinding mills,