Emerson LINDELL CF825AP00 Mode D'emploi page 21

6.14
Feed the Light Kit Fitter Assembly Pull Chain through the
Center Hole of the Bowl Cap (Figure 33).
Feed the Switch Cup Housing Pull Chain through the Off
Center Hole of the Bowl Cap (Figure 33).
Seat the Bowl Cap onto the Shade and screw the
Finial Nut onto the Threaded Screw to secure Shade
(Figure 33).
NOTE: Verify again that the Switch Cup Housing Pull
Chain does not make contact with the LED Light
Bulbs. If necessary reposition the Light Kit Fitter
Assembly to avoid the Switch Cup Housing Pull Chain
from touching the LED Light Bulbs.
6.15
Cut the off center Switch Cup Housing Pull Chain and the
Light Kit Fitter Assembly Pull Chain to the desired lengths
(Figure 34).
Position the small end of the Pendant (supplied) onto the
off center Switch Cup Housing Pull Chain, exposing the
Chain through the large end of the Pendant. Snap the
Coupling (supplied) onto the Switch Cup Housing Pull
Chain (Figure 34).
Position the small end of the Pendant (supplied) onto the
center Light Kit Fitter Assembly Pull Chain, exposing the
Chain through the large end of the Pendant. Snap the
Coupling (supplied) onto the Light Kit Fitter Assembly Pull
Chain (Figure 34).
You have now completed the assembly of your new
ceiling fan.
Please call Emerson
1-800-654-3545 if you
about installation and operation of this ceiling fan.
6. Final Assembly
technical support
have any questions
(Continued)
BOWL CAP
FINIAL NUT
Figure 33
LIGHT KIT FITTER
ASSEMBLY PULL CHAIN
at
PENDANT
COUPLING
Figure 34
21
SHADE
SWITCH CUP
HOUSING PULL
CHAIN
LIGHT KIT FITTER
ASSEMBLY PULL
CHAIN
SWITCH CUP
HOUSING PULL
CHAIN
PENDANT
COUPLING
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF825