Aligning The Appliance; Connecting The Appliance; Water Connection - Bosch B22CS51SNS Notice De Montage Et D'utilisation

Aligning the appliance

To ensure that the appliance functions correctly, it must
be set level with a spirit level.
If the appliance is not level, water may flow out of the ice
maker, ice cubes may be irregular or the doors may not
close properly.

Connecting the appliance

Have a technician install and connect the appliance
according to the enclosed installation instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
Always connect the water before the power.
Apart from statutory national regulations, you should
stick to the connection terms relating to the local
electricity and water companies.
After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time, clean
the interior of the appliance (see chapter "Cleaning
the appliance").

Water connection

The water may be connected only by a competent
plumber according to the local regulations of
the appropriate water supply company.
Connect the appliance to a drinking water line only:
Min. pressure: 0.2 MPa (2 bar / 29 psi)
■
Max. pressure: 0.8 MPa (8 bar / 116 psi)
■
If pressure exceeds 0.8 MPa (8 bar / 116 psi): Install
■
a pressure relief valve between the drinking water
connection and the tubing
Note:
The maximum outside diameter of the water line (without
connecting pieces) is 3/8" (10 mm).
en-us
9