Safety Instructions - ZANKER EHP663X Notice D'utilisation

EHP 663X
220-240 V 50-60-Hz
58 PEE 01 AO
ZANKER

Safety instructions

Warning! You must read these!
Make sure that the appliance is not damaged
because of transportation. Do not connect a
damaged appliance. If it is necessary, speak to the
supplier.
Only an authorised service technician can install,
connect or repair this appliance. Use only original
spare parts.
Only use built-in appliances after you assemble the
appliance into correct built-in units and work surfaces
that align to the standards.
Do not change the specifications or modify this
product. Risk of injury and damage to the appliance.
Fully obey the laws, ordinances, directives and
standards in force in the country where you use the
appliance (safety regulations, recycling regulations,
electrical safety rules etc.)!
Keep the minimum distances to other appliances and
units!
Install anti-shock protection, for example install the
drawers only with a protective floor directly below the
appliance!
Protect the cut surfaces of the worktop against
moisture with a correct sealant!
Seal the appliance to the work top with no space left
with a correct sealant!
10
Protect the bottom of the appliance from steam and
949 592 965 03
moisture, e.g. from a dishwasher or oven!
6,0 kW
Do not install the appliance adjacent to doors and
below windows! If not, hot cookware can be hit off the
hob when you open doors or windows.
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect plug and socket connections
can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F
Tmax 90°C (or higher) for a single-phase or two-
phase connection.
• Replace the damaged mains cable with a special
cable (type H05BB-F Tmax 90°C; or higher).
Speak your local Service Force Centre.
The appliance must have the electrical installation
which lets you disconnect the appliance from the
mains at all poles with a contact opening width of min-
imum 3 mm.
You must have correct isolation devices: line protect-
ing cut-outs, fuses (screw type fuses removed from
the holder), earth leakage trips and contactors.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical