Troubleshooting - Kemper 83 200 110 Mode D'emploi

10. Carefully place the disposal bag (item 16) over the contaminated filter
cartridge (item 15) without raising dust.
11. Remove the disposal bag (item 16) with the contaminated filter
cartridge (item 15) from the product.
12. Then seal the disposal bag (item 16) airtight with a cable tie and dispose
of it according to the applicable regulations.
13. Insert the new filter cartridges and fix them in place with the hexagon
nut + washer.
14. Further assembly is carried out in reverse order to the dismantling.
After replacing the filter, carry out the following steps:
15. Restore the compressed air and power supply.
16. Commission the product. See also the chapter Commissioning.

7.5 Troubleshooting

Fault
Product will not
start up
1502518-00
Fig. 49: Installing filter cartridges
Possible cause
Mains supply connection
not available
Start/stop sensor
connected but no current
detected
- 97 -
Note
Have it checked by a
qualified electrician
Check the start/stop
sensor, start the welding
process
EN