Truma Mover SE R Mode D'emploi / Instructions De Montage page 25

In order to guarantee the validity of the general operat-
ing permit (ABE), the data plates (f) provided must be
mounted on the left and right of the cross-strut between the
holding sheets for the drive assemblies.
Figure 22
Mark connection pipe in the centre. Loosely attach the drive
assemblies to the connection pipe.
Do not screw in the supplied threaded bolts (g) yet.
Figure 23
Place the drive assemblies with the connection pipe and
mounting set (b) on the vehicle frame and bolt them on with
the two bolts (c) in such a way that it is just possible to move
them along the frame.
The gripper (a) must rest completely on the chassis
frame.
a
b
Figure 24
b
Figure 25
f
g
c
Position the drive rollers in such a way that they are roughly at
wheel hub height / middle of wheel.
Driving direction
Figure 26
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets in order to compensate for this.
Spacer set 30 mm, part no. 60030-95000,
Spacer set 60 mm, part no. 60030-95100.
Make sure that there is adequate ground clearance (at least
110 mm).
Set the correct distance between tyres and rollers (20 mm)
with the spacer gauge provided by moving the drive as-
semblies (in the disengaged position) in the longitudinal
direction. The movable connection pipe makes it possible to
adjust to the frame width.
Driving direction
Figure 27
Move the drive assemblies in a lateral direction in such a
way that as much of the tread area of the tyre as possible is
covered.
Ensure that there is an adequate distance between the
gearbox and the tyres / shock absorbers so that they do not
come into contact.
The minimum distance with the drive rollers engaged is
10 mm.
Figure 28
Once the drive assemblies have been correctly positioned,
tighten the bolts (c) of the mounting set a little, then check the
required distances again. The weight of the caravan must be
resting on the wheels when doing this.
Place the movable connection pipe in the centre (use the
marking) and fix each side with 2 threaded bolts (g) M8 x 12
(15 Nm).
The threaded bolts are coated with sealant, and must
therefore only be bolted in once.
Re-check the distance of 20 mm from the tyre (with the
wheels under load). Then tighten the 2 bolts of the mounting
set (M10) alternately to 25 Nm.
± 30 mm
min. 110 mm
20 mm
min. 110 mm
25