Troubleshooting; Tuning The Electronic Control Unit To The Radio Remote Control; Technical Data - Truma Mover Se R Mode D'emploi / Instructions De Montage

Troubleshooting

Check that the batteries in the remote control are in immacu-
late condition!
Check whether the caravan plug has been plugged into the
safety socket!
Check whether the caravan battery is in immaculate condition
and is fully charged! Please note that battery performance can
deteriorate considerably at cold ambient temperatures.
Check whether the flat fuse (20 A) for the engagement
motors is OK. If the fuse is defective, check the engagement
motor connecting cables at the control unit for possible short
circuiting!
Perform a reset (approx. 10 seconds – briefly disconnect bat-
tery or disconnect and reconnect safety plug)!
If these actions do not remedy the problem, please contact
Truma Service.
Tuning the electronic control unit to the
radio remote control
The remote control and the control unit are tuned to
each other in the factory.
If the control unit or the remote control is replaced, they must
be tuned to each other again in accordance with the instruc-
tions below.
Check that installation has been carried out in accordance
with the installation instructions, and make sure that the
drive rollers are not engaged. Check that the battery is prop-
erly connected and in good condition, and that the control
unit is being supplied with 12 V. Make sure that the caravan
connector is plugged into the safety socket.
Press and hold the reset button (k) on the control unit
(red LED – j – flashes slowly), and after approx. 5 sec the
LED (j) flashes rapidly. Release the reset button and within
10 sec press and hold button (c) – caravan reverse – on the
remote control, at the same time switching the remote con-
trol on using the slide switch (a).
j
k
Figure 5
The remote control and the control unit are now tuned to each
other. Once tuning is complete, the red LED flashes fast.
20

Technical data

Operating voltage
12 V DC
Power consumption
on average approx. 35 A up to a maximum of 150 A
Quiescent current consumption
< 1 mA
Radio frequency
Class 1, 868 MHz
Speed
approx. 17 cm per second (depending on weight and slope)
Weight
approx. 33 kg
Engagement motor fuse
flat fuse 20 A
Positive line fuse
150 A
Usage, Mover® SE R
single-axle caravans with a gross weight of up to 2000 kg
Usage, Mover® TE R
dual-axle caravans with a gross weight of up to 2250 kg
Subject to technical changes.
a
c