Haussmann N1F-GT-300/4.0-B Manuel De L'utilisateur page 17

(A) tie cord as shown
(B) Connect Plug And Receptacle
IMPORTANT SAFETY INSTRUCTIONS
6) Use Right Appliance – Do not use appliance for any job except that for which it is
intended.
7) Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s)
or outlet(s) to be used for the gardening appliance. Receptacles are available having
built-in GFCI protection and may be used for this measure of safety.
WARNING!
To reduce the risk of electric shock, use only with an extension cord intended
for outdoor use, such as an extension cord of cord type SW-A, SOW-A, STW-A,
STOW-A, SJW-A, SJOW-A, SJTW-A. or SJTOW-A.
8) Extension Cord – Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized extension cord will cause a drop in line
voltage resulting in loss of power and overheating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord
25 Ft. (7.5 m)
50 Ft. (15 m)
100 Ft. (30 m)
To reduce the risk of disconnection of appliance cord from the extension cord
during operating:
i) Make a knot as shown in Figure Figure A &B;
ii) Use one of the plug-receptacle retaining straps or connectors described in this
manual.
10) Avoid Unintentional Starting – Don't carry plugged-in appliance with finger on
switch.
Be sure switch is off when plugging in.
11) Handle cord carefully – Never carry appliance by cord or yank it to disconnect
from receptacle. Keep cord from heat, oil, and sharp edges.
12) Don't Force Appliance – It will do the job better and with less likelihood of a
risk of injury at the rate for which it was designed.
13) Don't Overreach – Keep proper footing and balance at all times.
14) Stay Alert – Watch what you are doing. Use common sense. Do not operate
appliance when you are tired.
15) Disconnect Appliance – Disconnect the appliance from the power supply when
not in use, before servicing, when changing accessories such as blades, and
the like.
16) Keep guards in place and in working order.
17) Keep hands and feet away from cutting area.
Gauge
18 Gauge
16 Gauge
16 Gauge
17