Screen Saver - Weller WX 1 Mode D'emploi

Parameter menu

Screen saver

Screen saver
Robot output
34
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
Option Description
ON ON
OFF OFF
The robot output is on the back of the device.
The following options are available::
WX1: Off – On – ZeroSmog – Stop&Go
WX2/ WXD2: Off – left – right – left & right – ZeroSmog – Stop&Go
Option Description
left left tool channel (factory setting)
right right tool channel
left & right both tool channels
ZeroSmog The rear floating signal output is closed when
using a tool. Certain Zero Smog can be connected
with an optional adapter. The rear RS 232 port is
still functional.
Signal output is open in Standby, Off and Auto Off
modes or if no tool is inserted.
Stop&Go The rear RS232 port is used to drive an optotrans-
mitter so that a KHE-P can be activated via an
optical fibre.
If a tool is used, the output is set to High in order
to „activate" the transmitter. In addition, the floating
switched output is closed. Output is off in Standby,
Off and Auto Off modes or if no tool is inserted.
Note
If the robot is at working temperature, the display will show – ok –.
(Not available with Zero Smog)
Open Menu Station parameters 2
Open Menu Station parameters 2