Rotate Mode And Rotate & Repeat Mode - Brother P-touch 1400 Mode D'emploi

After selecting the Label Type mode NORMAL or VERTICAL, the label text can be
entered, formatted, printed and cut as usual. With the Normal Label Type mode, the
entered text is printed horizontally along the label. With the Vertical Label Type mode,
the entered text is printed vertically along the label.
Rotate Mode and Rotate & Repeat Mode
Labels printed using these Label Type modes can be wrapped
around cables and wires to mark them. With both of these
modes, the text is rotated 90° counterclockwise and each text
block printed on a separate label as shown below. With the
Rotate & Repeat mode, the text is printed repeatedly along
the length of the label so that it can easily be read from any
angle.
Rotate
Rotate
&
Repeat
After selecting the ROTATE or ROT-REP Label Type mode, specify the length of
each label and a frame style if desired.
●
BLK LEN. (block length): 0.80" to 8.00" (20 to 200 mm)
● FRAME:
☞ A single block of text can contain a maximum of 7 text lines, and with the ROT-REP
Label Type mode, only the text lines that fit within the label are printed.
☞ For labels to be attached to cables and wires, we recommend using Flexible ID Tape.
When wrapping Flexible ID Tape around cylindrical objects, the diameter of the
object should be at least 1/8" (3 mm), otherwise the FLAG Label Type mode should
be used. In addition, the overlapping ends of the label or the flag length should be at
least 3/16" (5 mm).
Block length Block length
Block length Block length
Default: 1.20" (30 mm)
OFF,
Default: OFF
Block length
Block length
, ,
3
1 2
,
4
11