Rotate Mode And Rotate & Repeat Mode - Brother P-touch 2460 Mode D'emploi

After selecting the Label Type mode NORMAL or VERTICAL, the label text can be
entered, formatted, printed and cut as usual. With the Normal Label Type mode, the
entered text is printed horizontally along the label. With the Vertical Label Type mode,
the entered text is printed vertically along the label.
Rotate Mode and Rotate & Repeat Mode
Labels printed using these Label Type modes can be
wrapped around cables and wires to mark them. With both
of these modes, the text is rotated 90° counterclockwise
and each text block printed on a separate label as shown
below. With the Rotate & Repeat mode, the text is printed
repeatedly along the length of the label so that it can easily
be read from any angle.
Rotate
Rotate
&
Repeat
After selecting the ROTATE or R & REP. Label Type mode, specify the length of each
label and a frame style if desired.
●
BL. LEN. (block length):
● FRAME:
☞ A single block of text can contain a maximum of 7 text lines, and with the R & REP.
Label Type mode, only the text lines that fit within the label are printed.
☞ For labels to be attached to cables and wires, we recommend using Flexible ID Tape.
When wrapping Flexible ID Tape around cylindrical objects, the diameter of the
object should be at least 3 mm, otherwise the FLAG Label Type mode should be
used. In addition, the overlapping ends of the label or the flag length should be at least
5 mm.
10
Block length Block length
Block length Block length
20 to 200 mm
Default: 30 mm
OFF,
Default: OFF
Block length
Block length
, ,
3
1 2
,
4