Brother P-touch 2460 Mode D'emploi page 47

Error Message
CHECK
BATTERIES!
CHECK SETTING IN
LABEL TYPE MODE!
CUTTER ERROR!
EXCEEDS PRINT
COPY LIMIT!
INPUT ABCD AT
BEGIN & END!
INPUT WHOLE
CODE!
LENGTH LIMIT!
42
Cause
• This message appears if a
combination of new and
used batteries, a combination
of batteries of different types
(alkaline, Ni-Cd and Ni-
MH), manufacturers or
models, or a combination of
recharged and uncharged
batteries have been installed.
• This message appears if you
try to change the settings for
the Length function or
Frame function after a Label
Type mode with a preset
label length or frame has
already been selected.
• This message appears if the
tape cutter button was
p
pressed in when
pressed or the tape was
being fed.
• This message appears if
more than 1000 copies were
selected with the Print
Option functions.
• Note the number of copies
plus the number of
sequential labels cannot
exceed 1000.
• This message appears if a
letter between A and D has not
been entered at the beginning
and end of the bar code data
when the CODABAR
protocol is selected.
• This message appears if the
required number of digits is not
entered in the bar code data.
• This message appears if you
try to print or use the
Preview function when the
length of the text is greater
than the 1 m limit.
Solution
• Replace the batteries with
six new AA batteries of the
same type.
• If rechargeable batteries are
installed, recharge all
batteries.
• Select a different Label
Type mode.
• Release the tape cutter
button. If
was
pressed, press
out any printed tape.
• If the problem cannot be
corrected, contact your
service representative.
• Select less than 1000 copies.
• Enter a letter between A and
D at the beginning and end
of the bar code data.
• Input the correct number of
digits or change the bar code
protocol.
• Delete some of the text.
p
was
f
to feed