Defrosting The Cooler; Replacing The Device Fuse; Replacing The Plug Fuse (12/24 V) - Dometic COOLFREEZE CF 35 Notice D'utilisation

CF35, CF40, CF50
6.8

Defrosting the cooler

Humidity can form frost in the interior of the cooling device or on the vaporiser. This
reduces the cooling capacity. Defrost the device in good time to avoid this.
A
NOTICE! Danger of damage!
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
To defrost the cooler, proceed as follows:
➤ Take out the contents of the cooling device.
➤ If necessary, place them in another cooling device to keep them cool.
➤ Switch off the device.
➤ Leave the cover open.
➤ Wipe off the defrosted water.
6.9

Replacing the device fuse

D
DANGER! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 4 2, page 4) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T4AL 250V).
➤ Press the fuse insert back into the housing.
6.10

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 7 4, page 5) off of the plug.
➤ Unscrew the screw (fig. 7 5, page 5) out of the upper half of the housing
(fig. 7 1, page 5).
➤ Carefully raise the upper half of the housing from the lower (fig. 7 6, page 5)
half.
➤ Take out the contact pin (fig. 7 3, page 5).
➤ Replace the defective fuse (fig. 7 2, page 5) with a new one that has the same
rating (8 A, 32 V).
EN
Operation
19