Engine Stop Button; Clutch Control - Husqvarna CR 125 2010 Livret D'utilisation Et D'entretien

HANDLEBAR COMMUTATOR (WR)
The left commutator has the following controls:

1) Engine stop button (

)
2) HI = ( ) Selection control High beam
LO = ( ) Selection control of Low beam
3) TURN
= Activation of left turn indicators (self cancelling)
= Activation of right turn indicators (self cancelling)
To deactivate the indicator, press the control lever after its re-
turning to center.
4) HORN = ( ) Warning horn
5) LIGHTS
= Lighting control of lowbeams and high beam.
= Lighting control of position lights.
= Off
14
ENGINE STOP BUTTON
(CR, WR USA-CDN)
On the left side of the handlebar, near the clutch control, is lo-
cated the engine stop button (1).

CLUTCH CONTROL

The clutch lever is located on the left-hand side of the handle-
bar and is protected against dirt filtering in. The lever support
is provided with adjusting screw (1) to regulate clutch wire free
play (see on page 22). The clutch
lever can be adjusted to suit your driving position.
CAUTION
Do not forget to tighten the screws (C) after
the adjustment.
A: To decrease clearance
B: To increase clearance
REAR BRAKE CONTROL
The rear brake control (1) is placed on the right-hand side of
the motorcycle. On models WR a stop switch, during the brak-
ing action, causes the rear light to come on.
1
1