Husqvarna CR 125 2010 Livret D'utilisation Et D'entretien page 94

HANDLEBAR POSITION AND HEIGHT CHANGE
The handlebar position (a) and height (b) can be changed for
better suiting Your driving requirements. To effect these opera-
tions, remove the upper clamp (1) and the lower one (2), af-
ter removing the fixing srews (3) and (4).
A
30
a) Handlebar position change
Turn the lower clamp (2) 180° to move forward or backward
(10mm- 0.04in.) the handlebar position with respect to the
original setup.
4
1
3
2
b) Handlebar height change
Remove the lower spacer (A) then replace the screw (4) with a
new one of L=65 mm (2.56 in.) height.
Once these operations are completed, tighten the screws (3) to
2,75-3,05 kgm (27-30 Nm; 19.9-22 Lb/fts) and the screws (4)
to 2,0-2,2 kgm (19,6-21,6 Nm; 14.5-15.9 Lb/fts
1
3
2
A