Set Up / Batteries - Health O Meter Welch Allyn PROPLUS 2500KGWA Mode D'emploi

SET UP / BATTERIES

®
ProPlus scales are shipped with the Menu Lock function enabled. The Menu Lock function
disables certain buttons on the scale's keypad, preventing unauthorized users from making
changes to your scale settings. The Menu Lock can be bypassed temporarily to allow you to
customize your scale with the functionality you prefer. Please refer to the ProPlus
Module User Manual for instructions on how to bypass the Menu Lock.
Preparing the Scale for Use
1. Remove protective plastic film covering the keypad and display.
2. Place batteries in the battery holder (see "Batteries" information in Figure 6,
below).
3. Plug the scale's power adapter into the power source.
4. Be sure all objects are removed from the scale's platform, and then press the
ON/OFF or I/O button to turn the scale on. The display will show "Health o meter
ProPlus" and then"0.0KG". Note: To adjust the display backlight and/or contrast,
please refer to the ProPlus
5. Press the KG button to select the weight mode (kilos). Note: The scale will
always default to the settings and units last used (KG).
6. When you disconnect the scale's power adapter from the power source, the
scale will switch to battery power, if batteries are installed. Note: If the set up
procedure failed, refer to the troubleshooting instructions. If the problem is not
corrected, refer to qualified service personnel.
Replacing / Inserting Batteries
1. Unplug the scale.
2. Remove the battery cover from the display assembly—refer to Figure 6 (A) above.
3. Disconnect battery holder cable connector from the scale-battery connector (B).
4. Carefully remove the battery holder (C) by sliding it out of the display assembly.
5. Replace the batteries with new ones. We recommend EVEREADY Energizer
6. Carefully slide the battery holder (C) into the display assembly.
7. Plug the battery holder cable connector to the scale-battery connector (B).
8. Attach the battery cover to the display assembly and install the screw (A).
Warning: If the scale will not be used for some time, remove batteries to avoid a safety hazard.
Disposal of batteries should be done according to the national, regional or local regulations which
apply to you for disposal of batteries.
®
Display Module User Manual.
Figure 6
- Batteries
10
®
Display
®
TM
e2 batteries.