Certifications / Disposal; Set Up / Batteries - Health O Meter 500KL Mode D'emploi

500KL CERTIFICATIONS / DISPOSAL
CERTIFICATION DESCRIPTIONS: CERTIFICATION DESCRIPTIONS
CERTIFICATION DESCRIPTIONS CERTIFICATION DESCRIPTIONS
500KL SCALE DISPOSAL 500KL SC 500KL SC 500KL SC ALE DISPOSAL: : : : ALE DISPOSAL ALE DISPOSAL
Do not dispose of this device in domestic waste. This Health o meter® Professional scale must be disposed of properly as
electronic waste. Follow the national, regional or local regulations which apply to you for disposal. For scale assistance or
telephone support, please call Health o meter® Professional Customer Service (available on normal business days) at
(+1) 800-815-6615 or (+1) 708-377-0600.

SET UP / BATTERIES

INSTALLING BATTERIES
1. Locate the battery compartment on the back of the display head.
2. With a Phillips screwdriver remove the screw from the battery compartment cover and remove cover.
3. Place 6 new AA alkaline batteries into the battery compartment. Make sure the '+' and '-' are positioned correctly, as shown on the
bottom of the battery compartment. Replace the batteries when the display reads 'LobAt' (Use only 6 AA alkaline batteries).
4. Replace the battery compartment cover.
NOTE: Dispose used batteries in accordance to your country's national, state or local requirements.
OPERATION WITH ADAPTER POWER
Plug the optional adapter (NOT INCLUDED) into the base of the scale and then into the outlet for power. Please refer to page 3 for
information regarding the adapters available for use with this scale. When an adapter is used, the battery icon will not be displayed.
The location of the adapter power jack on the scale (C) is shown below in Figure 1.
ASSEMBLING AND PREPARING THE SCALE FOR USE
1. Locate cable inside the upper column (A) and then feed it through the lower column (B).
2. After the cable is fed through (B), then plug the cable into the scale base (C).
3. Connect columns (A) and (B), then secure to base (C), using the 4 screws provided (see Figure 1).
4. Connect upper height rod (E) to lower height rod (F), then slide it into the slot at the top of the upper column (H).
5. Turn the scale on by pressing the ON/OFF button. The display will show "Start" and then "0.0".
NOTE: If set up instructions failed, refer to the troubleshooting instructions. If troubleshooting does not resolve the problem,
please contact Health o meter® Professional Technical Support at (+1) 800-815-6615 or (+1) 708-377-0600.
Products carrying this symbol meet the requirements of:
1. Directive for non-automatic weighing instruments 90/384/EEC
2. Directive governing medical devices 93/42/EEC
0470
Pelstar, LLC has been officially certified as a manufacture of Health o
meter® Professional medical devices to be in compliance with stringent legal
requirements. The Pelstar, LLC quality assurance system covers the
development, production, sales and service of medical scales and
measuring systems.
Figure 1
4