Replacing The Oven Door; Combination Units Microwave Trim Adjustment; Testing Operation - Thermador MASTERPIECE PROFESSIONAL Serie Instructions D'installation

3.
Guide the unit straight back into the cabinet cutout.
Push the unit straight in until the oven trim is about
2 inches from being flush with cabinet wall. Be careful
not to crimp the flexible conduit between the oven and
the cabinet back wall. If necessary, guide the flexible
conduit into the wall or cabinet access hole so it
doesn't prevent the unit from being pushed all the way
into the cabinet opening. The oven should be straight
and level, not crooked.
4.
Push the unit all the way back into the cabinet cutout
until the front edge of the unit is flush with the front of
the cabinet.
5.
Install the supplied screws through the tap holes in the
trim (2 screws for single ovens, 4 screws for double/
combo ovens). It is recommended to drill pilot holes
for the trim screws.
6.
Replace the oven door(s) according to the following
instructions.

Replacing the Oven Door

To replace the oven door:
1.
Hold the door firmly in both hands at a 30° angle to
the front of the unit.
2.
Guide the door hinges into the hinge slots on the unit
housing.
3.
Slide the door in until the slots on the hinges engage
the oven housing. Hint: it may be necessary to rock
the door slightly to seat it correctly.
4.
Lower the door into the fully open 90° position. If the
door will not lower all the way to the 90° position, the
hinges are not correctly seated. The door should be
straight, not crooked.
5.
Push the locking toggles back into the unlocked
position, toward the oven cavity.
6.
Reinstall the locking plates and screws (see door
removal process above).
7.
Close the door gently. It should close all the way.
Gently open and close the door several times to be
sure it is correctly installed and securely in place.

Testing Operation

1.
Turn on power at the breaker.
2.
Check power at junction box using a volt meter.
For 240 V installation, the reading between the red
and black wires (line to line) should be 220 to 240
volts.
For 208 V installation, the reading between the red
and black wires (line to line) should be 190 to 208
volts.
3.
Test the oven mode.
Select the BAKE mode. See the Use and Care Manual
for detailed operation instructions.
12
Combination Units Microwave Trim
Adjustment
During the installation of your Built-In Oven combination
unit it may be necessary to adjust the microwave trim
frame for a tight fit against the cabinet front. Determine if
alignment of the microwave trim frame is needed to fit
the trim tighter against the cabinet front.
1.
Measure the gap dimension to be closed and note on
which side it appears.
2.
Slide the Built-In Oven unit out from the cabinet 4 to 5
inches, enough to provide access to the adjustment
screws.
3.
Remove screws (A) and replace into adjustable slot
positions (B). Do not tighten the screws.
$
4.
Slide the trim frame as needed (C).
&
5.
Tighten the screws holding the trim frame.
6.
Slide the oven unit fully back into place in the cavity
and check to see if the alignment of the microwave
trim frame is satisfactory. If it is not, repeat the
procedure.
4.
Verify that the oven light comes on and the oven
begins to preheat.
5.
Test the door lock.
Set the SELF CLEAN mode. Confirm that the door
locks when the lock icon appears in the display.
6.
If installing a double oven, test the second oven as
well.
7.
If any of the tests do not result as explained above,
contact service for assistance. Otherwise, the
installation is complete at this time.
%