Table des Matières
Publicité
Before switching ON
Visual check if distance saw blade –riving knife is 3mm.
Visual check of power cable and power cable plug for damage; If necessary have damaged parts replaced
by a qualified electrician.
Monthly (if used daily)
Remove saw dust and chips with vacuum or brush; apply light coat of oil to guide elements:
-threaded rod and guide rods of blade rise and fall mechanism:
-swivel segments.
Symptoms
Machine does not start
Motor capacity is insufficient and is
Causing overheating
Cutting capacity is insufficient; A
burning
Smell upon starting the motor
1. Lower saw blade fully.
2. Adjust the bevel tilt to around 25 degree, and fold four legs.
3. Dismount add-on parts (fence, sliding carriage, table extension)
4. If possible use original carton for shipping.
MAINTENANCE
TROUBLESHOOTING GUIDE
Possible cause
1.Cable is defective or
broken
2.Blade is not turning due
to obstruction
3.motor or connections are
out of order
The extension is too long
or the section is too small
1.The machine has been
incorrectly assembled
2.A defect is present
TRANSPORTATION
WIRING DIAGRAM
8
EN
Solution
1.Chang feed cable
2.Remove obstructions
3.Have the motor or connections repaired
by an electrician, or make replacements
with new parts
Check conditions of use
1.Assemble the machine correctly
2.Replace the machine
Publicité
Table des Matières
