Operation; Setting The Depth Of Cut; Setting The Saw Blade Tilt; Sawing With The Rip Fence - LEMAN LOSST315 Manuel D'utilisation

SETTING THE DEPTH OF CUT

The saw blade's cutting height needs to be
adapted the height of the work-piece: the blade
guard shall rest with its front edge on the
work-piece.
Set the depth of cut by turning the handwheel
on the chipcase.
Note: To compensate for possible play in the
blade height setting mechanism, always raise
the blade to the desired position.

SETTING THE SAW BLADE TILT

The saw blade tilt is steplessly adjustable between 0 ° and 45 °.
1.Loosen the lock lever.
2.Using the handwheel set the desired blade tilt.
3.Tighten the lock lever to secure the saw blade in the set position.

SAWING WITH THE RIP FENCE

Note: When sawing with the rip fence the long fence extrusion must be used. And always use the push stick if the
distance between saw blade and rip fence is less than 120 mm.
1.The rip fence is placed from top onto the guide extrusion at the front of the saw and locked with the lock lever.
2.Set the cutting height of the saw blade. The blade guard must rest with its front edge on the workpiece.
3.Set saw blade tilt and lock.
4.Start motor.
5.Cut workpiece in a single pass.
6.Switch machine off if no further cutting is to be done immediately afterwards.

SAWING WITH THE MITRE FENCE

1.Swing mitre fence on the table top.
2.Set to desired mitre angle and lock in that position. For mitre cuts, the fence extrusion is adjustable to 45 °
3.Set the cutting height of the saw blade.
4.Set saw blade tilt and lock.
5.Start motor.
6.Cut workpiece in a single pass.
7.Switch machine off if no further cutting is to be done immediately afterwards.

OPERATION

7
EN