Saw Blade Installation - LEMAN LOSST315 Manuel D'utilisation

SAW BLADE INSTALLATION

1. Raise motor fully.
2. Take the blade, the centering flange, the tightening flange, the left side nut & adjusting washer.
In order, insert:
- adjusting washer
- centering flange
blade
-
tightening flange
-
- left side nut
3. Insert the riving knife and tighten the nuts so that the
blade guide can be made to slide according to safety
norms in force.
NOTE: The distance between the blade and the riving
Knife must be 3mm. Once this measurement is correct,
tighten the clamp screws of the blade guard.
4. Position the insert table into the Table top, and pull the
Insert table as show.
5. Install the blade guard on the riving knife, using the M5 self-locking nut & M5X50 screw.
6. Push one end of the suction hose on the blade guard's suction port
ASSEMBLY
5
EN