Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.11 Stability of the bandsaw
Before using the bandsaw, ensure the machines
upright stability is satisfactory.
The bandsaw has four Ø8mm holes (A) Fig. 13 in
it's base to allow it to be bolted to the floor or a
bench or alternatively to the optional workstand.
3.12 Dust extraction
The machine is fitted with a dust extraction port of
Ø100mm (B) Fig.14
It is recommended that when in use, the machine
is connected to a suitable dust extractor.
The dust extractor used should be able produce
an air speed of approx. 20 m / sec across the
extraction port area.
3.13 Lower blade guard
When open the lower bandwheel door on this
machine the lower blade guard (C) Fig. 15 swings
down.
When the lower door is closed the guard MUST be
raised back to its operating position.
The bandwheel doors MUST be closed at all times
when the machine is being operated.
3.14 Tilting the bandsaw table
To tilt the table to a specific angle.
Ensure the table is clear of loose objects.
Loosen the winged nut (D) Fig. 16 on the lower
trunion, then tilt the table to the angle required
using the scale (E) Fig. 16.
When the required setting is reached re-tighten
the winged nut to lock the table in position.
Note:- When using the table at an angle always
have the rip fence on the lower side of the
table to support the workpiece.
Fig.14
B
Fig. 16
E
- 5 -
GB
Fig.13
A
Fig. 15
D
C
Publicité
Table des Matières
