Olivetti d-Copia 300MF Guide De L'utilisateur page 95

OPERATION GUIDE
6 Upon completion of
all entries, press
[Connection Test] to
check the
connection.
NOTE:
Connected appears when connection to the destination is
correctly established. If Cannot connect appears, review the entry.
If you wish to specify another destination, go to the next step. If the
destination is only one, go to the step 8.
7 Press [Next Dest.] and repeat the steps 5 to 7 to specify the destination.
Up to 10 folders (total number of SMB and FTP folders) can be specified.
NOTE:
When [Add to Addr Book] is displayed, the entry is registered in
the address book.
8
Press [OK] to register the entry in the destination list.
9 Check the destination list.
Select a destination and press [Detail/Edit] to check and edit it. Edit it, if
necessary, referring to the steps 4 to 6.
Select a destination
and press [Delete] to
remove the
destination from the
list.
10
Change the original size, scan resolution, etc. if necessary.
Ready to send.
Place original.
Folder Path Entry
Host Name
SMB
Path
FTP
Login
User Name
Login
Password
Add to Addr Book Next Dest.
Status Executing TX job .
Ready to send.
Place original.
Destination
ABC SCANDATA
Chain Detail/Edit Delete
001 002 003
AAA BBB CCC DDD
006 007 008
FFF GGG HHH III
Destination Quick Setup Type of Original/
Transmission
Status Executing TX job .
Basic Operation
Destination
Connection
Test
Cancel OK
10/5/2006 10:10
Destination
Detail
Address
Book
To:
E-mail
1/1
Addr Entry
Folder Path
Entry
Recall
004 005 No.
EEE
009 010 1/10
JJJ
Color/Image Advanced
Setup
10/5/2006 10:10
3-27
1
1