Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
:
WARNING
ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use replacement parts
or accessories which are not intended for use with this tool. Contact HITACHI if you are not sure whether it
is safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
(1) Case (Code No. 333190) ........................................ 1
(2) Side Handle
I type: bar type handle
(Code No. 333214) ........................................... 1
II type: D type handle
(Code No. 333215) ........................................... 1
Either type I or type II Side handle is attached.
OPTIONAL ACCESSORIES ......
Demolishing
(1) Bull Point (SDS max shank type)
Overall
11-1/32"
Length
(280 mm)
Code No.
Groove digging and edging
(1) Cold chisel (SDS max shank type)
Overall
11-1/32"
Length
(280 mm)
Code No.
Asphalt Cutting
(1) Cutter (SDS max shank type)
Overall Length
Code No.
ACCESSORIES
sold separately
15-3/4"
(400 mm)
313471
313472
15-3/4"
(400 mm)
313473
313474
15-3/4" (400 mm)
313475
Scooping Work
(1) Scoop (SDS max shank type)
Overall Length
Code No.
Surface Roughing
(1) Bushing Tool
(Code No. 313477)
Tamping
(1) Rammer
(Code No. 313478)
Hammer Grease A
70g (in a tube) (Code No. 981840)
30g (in a tube) (Code No. 308471)
NOTE:
Specifications are subject to change without any
obligation on the part of the HITACHI.
English
15-3/4" (400 mm)
313476
(2) Shank
(Code No. 313479)
(2) Shank
(Code No. 313479)
11
Publicité
Table des Matières
