Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING:
ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use replacement parts or
accessories which are not intended for use with this tool. Contact HITACHI if you are not sure whether it is
safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
(1)Bull Point (SDS max shank) (Code No. 313471) ..... 1
(2)Case (Code No. 326511) ........................................... 1
(3)Side Handle (Code No. 317103) ............................... 1
OPTIONAL ACCESSORIES ............ sold
separately
Demolitioning
(1) Bull Point (SDS max shank type)
Overall Length 11-1/32" (280 mm) 15-3/4" (400 mm)
Code No.
313471
Groove digging and edging
(1) Cold chisel (SDS max shank type)
Overall Length 11-1/32" (280 mm) 15-3/4" (400 mm)
Code No.
313473
Asphalt Cutting
(1) Cutter (SDS max shank type)
Overall Length
Code No.
ACCESSORIES
313472
313474
15-3/4" (400 mm)
313475
Scooping Work
(1) Scoop (SDS max shank type)
Overall Length
Code No.
Surface Roughing
(1) Bushing Tool
(Code No. 313477)
Tamping
(1) Rammer
(Code No. 313478)
Hammer Grease A
30 g (in a tube) (Code No. 981840)
70 g (in a tube) (Code No. 308471)
NOTE:
Specifications are subject to change without any
obligation on the part of the HITACHI.
English
15-3/4" (400 mm)
313476
(2) Shank
(Code No. 313479)
(2) Shank
(Code No. 313479)
11
Publicité
Table des Matières
