Accessories; Standard Accessories; Optional Accessories - Hitachi H 45MR Instructions De Sécurité Et Mode D'emploi

English
WARNING:
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Bull Point (SDS max shank) (Code No. 313471) ............................................................... 1
(2) Case (Code No. 320842) ..................................................................................................... 1
(3) Side Handle (Code No. 317103) ......................................................................................... 1
(4) Allen Wrench (for 6 mm screw) (Code No. 944459) ........................................................ 1
(5) Allen Wrench (for 5 mm screw) (Code No. 944458) ........................................................ 1

OPTIONAL ACCESSORIES ........

Demolitioning
(1) Bull Point (SDS max shank type)
Groove digging and edging
(1) Cold chisel (SDS max shank type)
16

ACCESSORIES

ALWAYS use Only authorized HITACHI replacement parts and
accessories. NEVER use replacement parts or accessories which are
not intended for use with this tool. Contact HITACHI if you are not sure
whether it is safe to use a particular replacement part or accessory
with your tool.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.
Overall Length
Code No.
Overall Length
Code No.
sold separately
11-1/32" (280 mm) 15-3/4" (400 mm)
313471
11-1/32" (280 mm) 15-3/4" (400 mm)
313473
313472
313474