Hitachi H 45MR Instructions De Sécurité Et Mode D'emploi page 7

Masquer les pouces Voir aussi pour H 45MR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

13. Never use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
14. Never leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
15. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
16. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
17. ALWAYS wear eye protection that meets the requirement of the latest revision of ANSI
18. NEVER touch the tool bit with bare hands after operation.
19. NEVER wear gloves made from materials likely to roll up such as cotton, wool, cloth or
string, etc.
20. ALWAYS attach the side handle and securely grip the Demolition Hammer.
21. ALWAYS be careful with buried object such as an underground wiring.
Touching live wiring or electric cable with this tool may result in electric shock.
Confirm before use whether hidden objects are present, such as electric cables within
the wall, floor or ceiling.
22. Definitions for symbols used on this tool
V ............. volts
Hz ........... hertz
A ............. amperes
n
o .......... no load speed
W ............ watt
............ Class II Construction
---/min .... revolutions per minute
........... Alternating current
Standard Z87.1.
English
7

Publicité

Table des Matières
loading

Table des Matières