Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
For D type handle
The side handle can be fixed at any desired
position; 360 degrees, and can also be fixed at any
position in the back-and-forth direction.
(1) Loosen the handle by turning the grip in the
direction of
as shown in Fig. 6.
A
(2) Adjust it to a position where vertical (up-and-down)
operation can be facilitated as illustrated in Fig. 7,
Fig. 8, and Fig. 9.
(3) Turn the grip in the direction of
handle.
APPLICATIONS
Demolishing concrete, chiseling concrete, grooving,
bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply
and drainage work, interior jobs, harbor facilities
and other civil engineering work.
PRIOR TO OPERATION
1.
Power source
Ensure that the power source to be utilized
conforms to the power source requirements
specified on the product nameplate.
2.
Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch
is in the ON position, the power tool will start
operating immediately and can cause serious
injury.
3.
Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient
thickness and rated capacity. The extension cord
should be kept as short as practicable.
WARNING
Damaged cord must be replaced or
repaired.
8
and fix the
B
OPERATION
4.
5.
HOW TO USE THE DEMOLITION
HAMMER
1.
2.
:
Grip
A
B
Fig. 6
Fig. 8
Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause
overheating, resulting in a serious hazard.
Confirming condition of the environment:
Confirm that the work site is placed under
appropriate conditions conforming to prescribed
precautions.
After placing the tip of the tool on concrete surface,
switch ON.
The switch can be turned ON if the trigger is pulled
and OFF when it is released.
If the stopper is pressed while the trigger for the
switch is pulled, even if your finger is released from
the trigger, the switch remains ON - convenient for
continuous operation.
To turn the switch OFF, pull the trigger again, and
then the stopper comes off.
By utilizing the empty weight of the machine and
by firmly holding the demolition hammer with both
hands, one can effectively control the subsequent
recoil motion.
Proceed at a moderate work-rate, the use of too
much force will impair efficiency.
Fig. 7
Fig. 9
Publicité
Table des Matières
