Yamaha Motor YZ250 N/LC 2001 Manuel D'atelier Du Proprietaire page 118

1 CDI magneto lead
2 YPVS breather hose
3 Clamp
4 Clutch cable
5 Radiator breather hose
6 CDI unit lead
7 Cable guide
CABLE ROUTING DIAGRAM
A Pass the radiator breather hose
outside the engine bracket and
inside the down-tube.Pass the
radiator breather hose inside
the CDI magneto lead.
B Clamp the CDI magneto lead,
radiator breather hose and
YPVS breather hose. In so
doing, clamp the CDI magneto
lead at the rear of the down-
tube with the clamp ends for-
ward.
C Clamp the radiator breather
hose and CDI magneto lead at
the rear of the down-tube with
the clamp ends outward.
D Pass the clutch cable a little for-
ward of the extreme left nut that
holds the cylinder head.
2-14
SPEC
E Pass the radiator breather hose
and CDI magneto lead in front
of the radiator hose.
F Pass the radiator breather hose
and CDI magneto lead between
the frame and radiator.
G Align the top of the brake hose
neck with the brake hose holder
bottom.
H Pass the brake hose in front of
the axle boss,then fit it into the
hose groove so that the brake
hose does not contact the nut
(wheel axle).
I Fit the brake hose into the guide
on the protector.