3Doodler PRO Mode D'emploi page 9

SECTION 3: TIPS AND BEST
PRACTICES
Pay attention to Material types
and settings
• For optimal Doodling, we suggest using the correct temperature
settings for your Materials.
• DO double check which type of Material you are using before
you turn on the 3Doodler PRO and insert a strand.
Do not forget to snip your
Material Strand ends
• After removing a Material
strand from the 3Doodler, cut
and remove any partially melted
Material at the end of your
strand before re-feeding it into
the 3Doodler. This will reduce
blockages or clogging issues.
Reverse and remove Material
correctly
• DO NOT pull Strand from the back of the 3Doodler PRO other
than as directed.
1
BLUE Light
With the Pen set to the
appropriate temperature
setting, wait for the BLUE Light
to come on.
3
Once the Strand stops reversing, it is safe to remove it from the
Pen by gently pulling on the back of the strand.
Take a break
• DO give your 3Doodler PRO a rest after every 2 hours of
continuous Doodling. 30 minutes of down time should be plenty.
Treat your Nozzle right
• If you ever remove your
Nozzle, DO NOT remove it
when your 3Doodler is cold.
Light should be BLUE, set the
Temperature to (180°C/ 356°F).
• If you ever need to tighten
your Nozzle, DO NOT force
the Nozzle or overtighten it,
as you could break the Nozzle
and permanently damage your
3Doodler PRO.
Unsnipped Ends
2
Flashing
BLUE
Click Reverse Button once and
the Light will start flashing to
signal the Strand is reversing.
BLUE Light
180°C / 356°F
8
Snipped Ends
VS