3Doodler PRO Mode D'emploi page 5

7
x1
Press the Extrusion button once to stop extruding.
NOTE:
When Doodling, use the fan to control how fast or slow the
Material hardens. For quicker hardening, set the fan to HI
(increasing air flow). For slower hardening, set the fan to MED or
LO (decreasing air flow).
Step 3: Learning how to Doodle
in 2D
Use box below to create your first Doodle -
a triangle!
1
Draw a triangle in the box
provided using marker, pen,
pencil, or any other writing
utensil of your choice.
3
Doodle in a continuous
unbroken line by dragging the
Material along the paper as if
you were writing with a pencil,
with all letters connected. Keep
your movement slow and
steady.
5
Bend the paper outwards to
pop your triangle off.
Please Doodle here:
2
Click Extrusion button once.
When Material starts extruding,
push Nozzle down into paper to
get Material to stick to surface.
4
When you reach the end of the
triangle, be sure to connect the
two ends. Stop extruding by
clicking the Extrusion button
once again.
4