How It Works - 3Doodler PRO Mode D'emploi

SECTION 2: GETTING STARTED
WITH 3DOODLER PRO
We created this User Manual as a step-by-step guide
to get you comfortable with your 3Doodler PRO Pen
and its features. Once you are familiar with these
steps, you will be able to Doodle with confidence.
Skipping steps may result in a less enjoyable time with
your 3Doodler PRO.
EXTRUSION
BUTTON LEGEND:
• Click once to start
• Click once to stop
LIGHT LEGEND:
Solid RED:
Heating up
(Please wait)
BLUE:
Temperature reached
Flashing Blue:
Reversing Plastic
Tactile Speed Control
1
Adjust the extrusion
speed of your pen
Temperature Control
2
Adjust the temperature
settings of your pen
3
On/ Off Switch
Power Adaptor Port
4
Comes complete with power
adapter or battery pack for
untethered use
5
Light
LCD Display
6
Monitor target actual speed
and temperature settings
o C/ o F Toggle
7
Toggle the temperature
settings between celcius (
and Fahrenheit (
8
Reverse Button

How it Works:

The 3Doodler PRO melts Plastic and uses a motor and gears
(Drive Gear) to push it through the Pen's hot end (Nozzle) in a
thin line. This process is called extruding or extrusion, and we will
refer to it throughout this User Manual. Once extruded, Material
hardens nearly instantly, allowing you to draw on surfaces and in
the air. This User Manual will show you how!
When the PRO is turned on, the LED will light up red. When it reaches
the target temperature the LED will light up blue.
LCD Temperature:
When changing temperature,
the new target temperature will
flash on the LCD screen. The
LCD screen will then display the
current temperature in real time
as it changes.
How do I switch the display from celcius to Fahrenheit?
There is a tiny hole located underneath the LCD display screen where you
can insert a paperclip (and press down) to switch the temperature display
o
from Celsius (
o
Celsius ( C).
1
2
3
F)
o
C) to Fahrenheit (
4
9
10
11
12
13
14
o C)
15
LCD Speed:
When changing speed, the new
speed will show on the LCD for a
few seconds as the pen adjusts.
o
F). The temperature rating defaults to
2
5
6
7
8
9
Extrusion Button
Plastic Loading Port
Fan Speed Switch
Control the rate materials
harden to suit your needs
Control Port
Nose Cone
Nozzle
Hot end where Strand is
extruded for Doodling
Material Strand
15
10
11
12
13
14