3Doodler PRO Mode D'emploi page 8

Step 7: Let's Switch Plastic!
1
PLA Plastic
Switch your pen's temperature and speed settings for the
chosen Material with reference to the Material Use Guidelines.
Load the desired new strand into Plastic Loading Port.
2
Push the Material through
the back of Pen and click the
Extrusion Button once. Wait
until strand starts to pull
through on its own.
Step 8: Power Down
1
Remove all Material from the Pen using the Reverse feature
(as shown in Step 6). Friendly reminder to snip those ends!
2
Move the On/ Off Switch
to OFF.
NOTE:
After 10 minutes of inactivity, the 3Doodler PRO's heating
system will automatically power down. You will need to press the
Extrusion Button OR toggle the Power Switch OFF and then ON
again to continue use.
TAKE A BREAK:
We recommend powering down and giving your 3Doodler
PRO a 30 minute break after every 2 hours of continuous use.
x1
BLUE Light
3
x1
Click Extrusion Button once
to continue extruding your
new Material and Doodle as
you wish.
3
Allow your 3Doodler PRO to
cool completely before storing.
7
Power Adapter