3Doodler PRO Mode D'emploi page 16

4. My Material is leaking from
around the Nozzle.
Nozzle may loosen with continued
usage (or in transit). While Pen is hot
(BLUE Light on), set the temperature
to (180 °C / 356 °F) gently turn Nozzle
clockwise to tighten it using the
Nozzle Tool located on the bottom
of the Nozzle Set Case provided.
Stop tightening once you first feel
resistance so as to avoid
over-tightening the Nozzle and
breaking it.
5. My Material won't stop
extruding.
A. Click the Extrusion Button once.
B. If Step A does not solve this problem, please unplug your
3Doodler PRO and then plug it in and try again.
6. How do I reverse my
unused Strand?
While the Pen is on ( appropriate temperature setting ) and hot
(BLUE Light), click the Reverse Button. Light will start flashing to
signal the Strand is reversing. Once the Strand stops reversing,
it is safe to remove it from the Pen by gently pulling on the back
of the strand.
If Strand is too short to reverse, see Section 3, Step 3B.
Snip the ends of your Strands now for easier loading
TIP
and Doodling later.
7. I have reversed my Strand but
cannot get it out.
It is possible that the Strand is either too short to reverse all the
way out of your 3Doodler PRO, or that the Strand has moved past
the Pen's Drive Gear system.
Strand reversed, but too short to take out and no longer in
contact with the Drive Gear.
Strand is beyond Drive Gear.
For both of these issues, you can try the following options:
• Insert a new strand or Unblocking Tool to push the remaining
Plastic through while Pen is ON and extruding.
Or
• Remove Nozzle and use
Unblocking Tool to push Plastic out the back of the Pen.
(See Section 3, Step 3B).
15
Nozzle
Set