3Doodler PRO Mode D'emploi page 11

SECTION 5: NOZZLE SET
MANUAL
IMPORTANT NOTES
Read all instructions and warnings prior to using
this product. Improper use of this product may
result in product damage, excess heat, toxic fumes,
fire or explosion, damages for which you, and not
the manufacturer are responsible.
Always ensure that your 3Doodler PRO is
-
warmed up, with the blue LED light on.
Set the temperature to (180°C/ 356°F).
Attempting to remove the nozzle when the
3Doodler PRO is cool will irreparably damage it.
Take care not to use excessive force when
-
removing or screwing on a new nozzle. Make
sure that the nozzle is screwed on firmly
without forcing it. Excessive force will damage
your 3Doodler PRO.
While it is normal for there to be plastic inside
-
the nozzle itself, please ensure that the exterior
of the nozzle is clean when removing or
replacing it. This will prevent the nozzle from
becoming stuck inside the removal tool.
Clean the nozzle while it is hot using a cloth or
-
a folded up tissue, being sure to keep enough
material between your fingers and the hot
nozzle so as to protect your fingertips from
burning.
SWAPPING NOZZLES
Step 1: Plug in your 3Doodler PRO (A), set the power
switch to ON, and wait for the LED light to turn
BLUE (HI). Set the temperature to (180°C/ 356°F).
Step 2: Remove the nozzle (B) by turning the nozzle
tool (C) counter-clockwise (D). Please be careful not to
touch the nozzle, it's very hot!
Step 3: Insert the new nozzle into the nozzle tool with
the screw/base facing outwards. Again, it is okay for
there to be residual plastic inside the nozzle.
Step 4: Press the extrusion button so that the pen
heats up again. Once the pen is hot, screw the nozzle
onto the pen, turning the nozzle tool clockwise (E) to
tighten the nozzle onto the pen. Make sure the nozzle
is screwed on firmly, but don't force it!
Step 5: You're ready to start Doodling!
Step 6: When you're done, don't forget to store your
nozzles (F)!
10