3Doodler PRO Mode D'emploi page 17

8. My Pen won't heat up!
(light stays red).
ut Power: 6W
ut Voltage: 5V
It takes around 60-90 seconds for your Pen to heat up. If, after
Voltage: 5V
that time, the Pen still does not heat up and the LIGHT remains
RED, turn the Pen OFF and ON and try again. If that still does not
work, please contact us at help@the3Doodler.com and we will
are and maintenance information, and more advice on how to use your
assist further.
dler, please refer to our website: the3Doodler.com
LIMITED WARRANTY
For more details on your limited warranty, please visit:
the3Doodler.com/warranty
Doodler.com/warranty
For 3Doodler's Terms and Conditions and other notices please refer to our
website: the3Doodler.com/terms-and-conditions
This marking indicates that this product should not be disposed
of with other household wastes. To prevent possible harm to the
environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
This marking indicates that this product should not be disposed of with
guarantee that interference will not occur in a particular installation.
other household wastes. To prevent possible harm to the environment or
If this equipment does cause harmful interference to radio or television
human health from uncontrolled waste disposal, recycle it responsibly to
reception, which can be
promote the sustainable reuse of material resources.
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
device complies with part 15 of the FCC Rules. Operation is subject to the
measures:
wing two conditions: (1) This device may not cause harmful interference, and
- Reorient or relocate the receiving antenna.
cause undesired operation.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
Unblocking Tool
16