3Doodler PRO Mode D'emploi page 7

Step 6: Reverse and Remove
Strand
1
BLUE Light
While keeping the Pen
temperature set for ABS, wait
for Blue Light to come on.
3
Once Material stops reversing, it is safe to remove it from the
Pen by gently pulling on the back of the strand.
SNIP THOSE ENDS!
TIP
After removing a Material
strand from the 3Doodler PRO,
cut and remove any partially
melted material at the end of
your strand before re-feeding
it into the 3Doodler PRO. This
will reduce blockages and
clogging issues.
NOTE:
Material strands that are shorter than 6.5 inches cannot be
reversed. You should feed it all the way through your 3Doodler
PRO and use it up.
MATERIAL USE GUIDELINES
PLA
(When using PLA always have fan set to HI)
• Sticks to a variety of surfaces
• Glossy finish
METAL
(When using METAL always have fan set to HI)
• Sand and polish for shimmer
• Uses real metal
WOOD
• Uses real wood fiber
• Sand it, stain it, and fill in
wooden cracks
ABS
• Hardens quickly
• Perfect for drawing in the air
FLEXY
• Best for Doodles that need
to bend
• Flexible and stretchy
NYLON
• Strong, Flexible and Durable
• Make functional parts or add
clothing dyes
• Use clothing dyes to color
POLYCARBONATE
• Resists high temperatures
• Cools super fast with a
rigid finish
1. Please do not exceed the suggested maximum temperature
for any materials.
2. Speeds are suggestions only and may be modified.
3. ALWAYS remove strand from pen when pen is idle.
2
Click the Reverse Button once.
Light will start flashing to signal
Plastic reversing.
6.5
inches
o C ( o F) *
195-220
(383-428)
180-200
(356-392)
170-200
(338-392)
200-240
(392-464)
200-230
(392-446)
200-225
(392-437)
220-240
(428-464)
6
Flashing
BLUE
SPEED
3-5
3-6
3-6
3-6
2-5
3-6
3-6