3Doodler PRO Mode D'emploi page 4

Step 1: Turn on your 3Doodler
PRO and Doodle with ABS
1
Power Adapter
Plug in 3Doodler PRO Pen.
How to set temperature and speed
on the 3Doodler PRO
To increase temperature
by 5 degrees, twist the dial
towards the (+) symbol, and
then recenter. The LCD should
reflect the new temperature.
Repeat this step until desired
temperature is reached.
The same procedure applies to
increase or decrease speed by 1
3
Light will glow RED while the Pen is reaching the temperature
required to melt your Plastic. Once Light has turned BLUE,
your Pen is ready to extrude Plastic.
Start Doodling with ABS while you get to grips with your
3Doodler PRO.
Step 2: Load and extrude Plastic
1
Select one strand of ABS
(MATTE) Plastic (provided in
your 3Doodler PRO box).
3
Making sure the Light is BLUE,
push the Plastic through the
Filament Loading Port.
5
Gently push Plastic into
Filament Loading Port until
you feel the strand pulled
through the Drive Gear on
its own.
Light to BLUE
BLUE Light
2
Slide Fan Speed Switch to HI.
To decrease temperature
by 5 degrees, twist the dial
towards the (-) symbol, and
then recenter. The LCD should
reflect the new temperature.
Repeat this step until desired
temperature is reached.
2
Refer to the Materials Snapshot
and set the 3Doodler PRO to
the correct ABS temperature
and speed settings
(200ºC-240ºC / 3-6). Also turn on
the Fan Speed Switch on HI.
4
x1
Click the Extrusion button
button once and release. You
will hear the Drive Gear start.
6
After 10-15 seconds, Plastic
will begin extruding from the
Nozzle. Extruded Plastic will
harden after a few seconds.
3
10-15
secs