Safety Notices - Aim TTi TGR2050 Serie Guide De Démarrage Rapide

2 - Safety

Safety notices

Safety notices
This instrument is:
· A safety Class I instrument according to IEC classification and has been designed to meet
the requirements of EN61010-1 (Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use).
· An Installation Category II instrument intended for operation from a normal single-phase
supply.
· Tested in accordance with EN61010-1 and has been supplied in a safe condition.
· Designed for indoor use in a Pollution Degree 2 environment in the temperature range 5°C
to 40°C, 20% - 80% RH (non-condensing).
WARNING
Do not operate while condensation is present.
Do not operate outside its rated supply voltages or environmental range.
THIS INSTRUMENT MUST BE EARTHED.
Any interruption of the mains earth connector, inside or outside, will make the instrument
dangerous. Intentional interruption is prohibited.
Any adjustment, maintenance and repair of the opened instrument under voltage must be avoided.
When connected, terminals may be live and opening the covers or removal of parts (except those
that can be accessed by hand) may expose live parts.
To avoid electric shock, or damage to the instrument, never allow water to get inside the case.
If the instrument is clearly defective, has been subject to mechanical damage, excessive moisture
or chemical corrosion the safety protection may be impaired and it must be withdrawn from use
and returned for checking and repair.
Ensure that only fuses with the required rated current and of the specified type are used for
replacement. The use of makeshift fuses and the short-circuiting of fuse holders is prohibited.
This instrument uses a Lithium button cell for non-volatile memory battery back-up; typical life is 5
years. In the event of replacement becoming necessary, replace only with a cell of the correct type,
i.e. 3V Li/Mn0
accordance with local regulations; do not cut open, incinerate, expose to temperatures above 60°C
or attempt to recharge.
CAUTION
Do not wet when cleaning, use only a soft dry cloth to clean the screen.
5
20mm button cell type 2032. Exhausted cells must be disposed of carefully in
2
TGR2050 Series Quick Start Guide