7 - Basic setup examples
Step sweep - (Touch screen)
Step sweep - (Touch screen)
Requirement
Continuously sweep an RF signal with a frequency ranging from 500MHz to 1GHz and amplitude
from -20dBm to -10dBm; in 100 linear steps with a 1 second dwell time between each step; using
touch screen only.
Starting conditions
Before starting, reset the instrument to default settings as described in 'Initial Conditions'.
Touch the Sweep button.
Enter sweep menu
•
Touch the Start Freq. parameter window, touch again to edit.
Set start and stop frequency
Touch 500, then MHz, followed by OK.
•
Touch the Stop Freq. parameter window, touch again to edit.
•
Touch 1, then GHz, followed by OK.
•
•
Touch the Start Ampl. parameter window, touch again to edit.
Set start and stop amplitude
Touch +/- to show the - symbol.
•
Touch 20, then dBm, followed by OK.
•
Touch the Stop Ampl. parameter window, touch again to edit.
•
Touch +/- to show the - symbol.
•
Touch 10, then dBm, followed by OK.
•
•
Touch the Length parameter window, touch again to edit.
Set number of steps in the sweep length
Touch 100, followed by OK.
•
•
Touch the Dwell parameter window, touch again to edit.
Set dwell time
Touch 1, then S, followed by OK.
•
•
Switch output on
•
Press the [RF On] hard key.
Touch the Run button.
Run sweep
•
14
TGR2050 Series Quick Start Guide