Beurer MP 52 Mode D'emploi page 23

6. You can select the speed of the drive axle using the plus (+) and minus
(-) speed regulation buttons
and then increase as required.
7. Do not press too hard and always carefully move the attachments to-
wards the area to be treated. Move the device over the area to be treat-
ed and apply slight pressure while slowly moving the device in circles.
8. When filing, always move from the outside of the nail towards the tip.
Check the results regularly during the treatment. Stop treatment as
soon as it becomes unpleasant. Do not remove the entire callus to
maintain natural skin protection.
9. Ensure the axle can always rotate freely. If the axle is blocked for
approx. 3 seconds, the device switches off to protect the motor. To
indicate that the motor protection has been activated, the LED status
display flashes blue. The device then switches to standby mode
4
and the LED status display
10. Apply moisturiser to the treated areas after each use.
The device switches off automatically after 20 minutes.
. Start each application at a low speed
3
lights up permanently in blue.
4
23