Device Use; Operating Instructions - I-Tech MIO-CARE PRO Notice D'utilisation

Make sure that MIO-CARE PRO is switched off before disconnecting
the electrodes at the end of the treatment.

Device use

MIO-CARE PRO has 14 preadjusted TENS programs, 21 preadjusted NEMS
programs, 15 preadjusted BEAUTY programs and 12 free memories adjustable
by the user to create programs according to his needs. The program MEM 13
is a battery test.

Operating instructions

It is recommended reading the entire user manual before using.
To start the therapy, turn MIO-CARE PRO on using the
PREADJUSTED PROGRAMS
Read the follow instructions to use the preadjusted programs and start the
therapy:
1. Select the program group using the MODE/ESC button (NEMS, TENS,
BEAUTY, MEM).
2. Select the program using PRG+ and PRG- buttons (make reference to
the follow sections to get all technical specifications).
3. Increase current intensity for the channels using CH1 and CH2 (▲)
buttons. The value can be adjusted with stepping 1mA. Press CH1
and CH2 (▼) buttons to decrease the intensity.MIO-CARE PRO
recognize the electrodes connection: in case of faulty connection,
when the intensity reaches 15mA the value is resetted to zero.
4. The remaining time is showed on the display of MIO-CARE PRO. An
acoustic signal advises the user when the treatment is completed.
5. Turn off the device keeping pressed the
two seconds.
FREE MEMORIES (ADJUSTABLE PROGRAMS)
With MIO-CARE PRO you can set the parameters according to your needs or
indicated by the doctor/physical therapist using the MEM programs.
Read the following instructions to adjust the parameters:
1. Select MEM by pressing MODE/ESC button. Scroll the programs
using PRG+ and PRG- buttons to display the preadjusted technical
specifications. Read the following instructions to adjust the chosen
program parameters: time, frequency and width impulse.
IACER Srl 75
button.
button for at least
MNPG148-05