Bosch GCM 12 JL Professional Notice Originale page 28

OBJ_BUCH-1600-005.book Page 28 Friday, December 16, 2016 9:23 AM
28 | English
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols can be important for the operation of
your power tool. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the power tool better and more safely.
Symbols and their meaning
 Laser radiation
Do not expose users of telescopic
optics
Class 1M laser product
 Keep hands away from the cutting
area while the machine is running.
Danger of injury when coming in con-
tact with the saw blade.
 Wear a dust respirator.
 Wear safety goggles.
 Wear ear protectors. Exposure to
noise can cause hearing loss.
 Danger area! Keep hands, fingers or
arms away from this area.
Observe the dimensions of the saw blade.
The hole diameter must match the tool
spindle without play. Do not use reducers
or adapters.
1 609 92A 348 | (16.12.16)
Symbols and their meaning
 Always adjust the saw-
table extensions proper-
ly in order to underlay or
support long workpieces
at their free end. Work-
pieces that are not suffi-
ciently underlaid can tilt or
tip over during sawing. This
can lead to injury or dam-
age the power tool.
 Always saw with the
distance-stops inserted.
Without distance-stops,
the contact surface is too
small and the workpiece
cannot be sufficiently
secured for sawing.
100x100mm
In order to saw workpieces higher than
75 mm, the distance-stops must be in-
serted at the front position on both sides.
The distance-stops always must be in line
to each other, so that a straight contact
surface for the workpiece is achieved.
Bosch Power Tools