Set Time Format - SOUNDMASTER IR45SW Manuel D'instructions

LAN Network
Connect the Ethernet port to one of the LAN ports in a router or Wi-Fi router using CAT 5 or
CAT 6 cable. If your Router or Wi-Fi router is DHCP-enabled (recommended), you don't have
anything to setup and the unit will connect to internet with the parameters automatically
assigned by the Router/Wi-Fi router.
Use the remote control for configuration if you want to use a fixed IP, scroll to IP:[Dynamic] and
press "OK". Choose Fixed. Press the ▲ button, you can then enter the IP, press ▲ / ▼ to
tune to the required numbers: xxx.xxx.xxx.xxx. Switch among the 4 groups by pressing ◄ / ►.
When done, press "OK". Scroll to GW and NM to do the same.
You can also choose to use a DNS server other than the one from the DHCP server. Scroll to
DNS and do the same.
Note - Use DHCP to get the network parameters unless you are familiar with network setup.
Date and Time
The radio will set your local time automatically after the internet connection is completed. If you
want to do manual setting, change it by the following options:
 Time zone
Auto-set Time Zone: This option is set by default.
Manual-set Time Zone: Choose this option if you want to set the time in another region.
 Set Time Format
Choose either 12-hour or 24-hour notation you prefer.
 Set Date Format
NTP (Use network time)
NTP is designed to synchronize a device's clock with a time server. Your unit will
synchronize the time server by default every time it powers up and connects to Internet.
This ensures a very high degree of accuracy in the unit's clock. You can change to use
other time server by inputting the URL address (see below NTP server). You can choose
"Do not use network time" if you don't want it to.
If you choose not to use NTP for clock synchronization, highlight the NTP (Network time
protocal) and press "OK" to make the change. You will see the Set Date & Time
appeared on the menu. Select it and adjust the date and time as you desire.
NTP Server
NTP is designed to synchronize a device's clock with a time server. Here it shows the
server being used for the unit.
Choose and highlight the region/city you prefer and press "OK"
to confirm.
Coupled with NTP (use network time) and DST (Daylight time
saving) will be adjusted automatically if you choose to use
network time (NTP).
11
IR45SW / English Instruction Manual