Network Setup - SOUNDMASTER IR45SW Manuel D'instructions

 Plug in the DC adapter and switch the Power on/off switch (on the rear cabinet) to ON.
Press "Power" button on the front (Power LED will be briefly lit).
 Caution: Use only the adaptor supplied with the radio. Connecting a power supply with a
different rating will cause permanent damage to the radio and may be hazardous.
 The unit is intended to connect with external powered speaker. It does not have amplifier
and speaker driver built-in. Please connect your stereo through the Analogue output or
Digital output located on the rear panel of the unit for listening.
Note: All radio modes work through Analogue and Digital output, except DAB and FM which
work only with Analogue output.
Internet connection can be setup via Wired LAN or Wireless LAN (WiFi).
Your unit requires a broadband Internet connection through wired Ethernet or WiFi. The easiest
way is use a CAT 5 or CAT 6 cable to connect through wired Ethernet to a Wifi router, which
connects to an Adsl modem or a cable modem provided by your ISP.
Wired LAN(Ethernet)
For Wired Ethernet connection to a router with DHCP enabled, the network configuration for
Internet connection is automatically done and the unit can be used for Internet radio and UPnP
sharing without user interaction.
Wireless LAN (Wi-Fi)
Using remote control
On the alpha-numerical keypad, press each button repeatedly to cycle through the letters,
numbers and symbols as listed below. To input a character, scroll to the correct one and when it
is highlighted, press the
character of the password and it is highlighted, press "OK" to confirm.
Button 1: 1 and different kind of symbols !@#$%^&*()_+[]{};:'"\|,./<>?
Button 2: 2ABCabc
Button 3: 3DEFdef
Button 4: 4GHIghi
Button 5: 5JKLjkl
Button 6: 6MNOmno
Button 7: 7PQRSpqrs
Button 8: 8TUVtuv
Button 9: 9WXYZwxyz
Button 0: 0
Using control button on the unit
Use the "Dial/OK" knob to scroll through the characters, when the correct one is highlighted,
press "Forward/Right" button to input the next character. When it comes to the last character
of the password and it is highlighted, press "Dial/OK" to confirm.
Note: The security code is case sensitive.
INSTALLATION

NETWORK SETUP

button to input the next character. When it comes to the last
IR45SW / English Instruction Manual
3