Switching The Appliance On; Operating Tips - Bosch KIF20 Serie Notice D'utilisation

Controls
Fig. 2
1
On/Off button
Serves to switch the whole
appliance on and off.
2
Temperature selection button
The required temperature is set
with this button.
3
"cold + fresh" display
Illuminates, if the appliance is
in operation.
4
Refrigerator compartment
display
Indicates the current temperature
setting in the refrigerator
compartment.
Switching
the appliance on
Fig. 2
Switch on the appliance with the On/Off
button 1.
The temperature display 4 indicates
the selected temperature. Displays 3
"cold+fresh" come on.
The appliance starts to cool, the light is
switched on when the door is open.
We recommend a setting of +4 °C.
Perishable food should not be stored
above +4 °C.

Operating tips

After the appliance has been switched
■
on, it may take several hours until
the set temperature has been
reached.
Do not put any food in the appliance
beforehand.
While the refrigeration unit is running,
■
water droplets or a thin layer of ice
may form at the rear panel of the
refrigerator. This is nothing unusual.
It is not necessary to scrape off the
frost or wipe off the water droplets.
The rear panel defrosts automatically.
The condensation flows into the
evaporation area of the appliance via
the condensation channels and the
drainage hole.
The partition in the lower "cool-fresh"
■
container is required for functional
reasons and should not be removed.
The temperature behind the partition is
lower than in the front area of the
container.
en
25