Cleaning And Troubleshooting Your Waterpik - Waterpik WP-672 Mode D'emploi

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

ON
OFF
ON
OFF
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial
solutions. After using any special solution, rinse unit to prevent clogging by partially
filling reservoir with warm water and running unit with tip pointed into sink until unit
is empty.
Accessory Storage
Accessory tip storage for your two most frequently used tips is under the reservoir
lid and can be easily accessed by removing the reservoir.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when necessary
by using a soft cloth and mild non-abrasive cleanser.
The water reservoir is removable for easy cleaning and is top rack dishwasher safe.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of
you water. If left unattended, it can hinder performance. Cleaning internal parts: add
2 tablespoons of white vinegar to a full reservoir of warm water. Point the handle
and tip into sink. Turn unit ON and run until reservoir is empty. Rinse by repeating
with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be purchased
at www.waterpik.com or contact Water Pik Inc. customer service for a self service
repair kit.
WATER FLOSSER
®
9