Hydro-Pulse Massage Mode - Waterpik WP-672 Mode D'emploi

Upper Arch
30 sec.
30 sec.
Lower Arch
Mode
Floss
Massage
One-Minute Timer/30-second Pacer (Floss Mode Only)
The Water Flosser will create a short pause at 30-seconds, to remind you to move
to the other arch of your mouth and another short pause at 1-minute to signal you
have reached the recommended cleaning time. The unit will continue to run without
pauses until the unit is turned off. Depending on the pressure setting, some water
will remain in the reservoir after 1-minute.
Timer may be deactivated if desired. Steps to deactivate:
1. While unit is off, press the mode button once to wake the unit up.
One of the LEDs should light up.
2. Press and hold the mode button for approximately 3-seconds until the Massage
Mode light blinks. The timer is now deactivated.
If you wish to reactivate the timer:
1. While unit is off, press the mode button once to wake the unit up. One of the
LEDs should light up.
2. Press and hold the mode button for approximately 3-seconds until the Floss
Mode light blinks. The timer is now activated.
Or unplug unit to reset to factory settings.

Hydro-Pulse Massage Mode

Hydro-Pulse Massage offers a unique water pulsation pattern designed to enhance
gum stimulation. For best results, use the Floss Mode as instructed. After using Floss
Mode for 1-minute, switch the unit to Massage Mode, adjust pressure as desired, and
aim the water stream at your gums and massage throughout your mouth.
To determine in which mode the unit is set while it is off simply press mode button
and the LED light will indicate current mode. To change mode, press mode button
again. You may also press the mode button while unit is on to change mode during
use.
When Finished
Turn the power OFF. Empty any liquid left in the reservoir. Unplug the unit.
Note: If you used mouthwash or other solution besides water, see "Using
Mouthwash and Other Solutions" section.
7